User's Manual
Table Of Contents
- Introduction
- About This Guide
- Parts of the SPT 1800
- Parts of the SPT 1800 (continued)
- Parts of the SPT 1800 (continued)
- Getting Started
- Installing the SIM Card (SPT 1834 Only)
- Installing the Battery
- Starting the SPT 1800
- Using the SPT 1800
- Resetting the SPT 1800
- Attaching the Handstrap
- Scanning 1-D Bar Codes
- Scanning PDF417 (2-D) Bar Codes
- Initiating a Network Connection
- Maintaining the SPT 1800
- Troubleshooting
- Ergonomic Recommendations
- Regulatory Information
- Battery Caution
7
Quick Reference
Using the Cradle to Charge the Battery
1. Ensure the battery is installed in the
terminal.
2. Plug the cradle into a wall outlet.
3. Insert the SPT 1800 into the cradle.
The terminal’s battery is fully charged after
approximately two hours. You can also charge a
spare battery by inserting it into the spare
battery charging slot on the back of the single
slot cradle. The spare battery fully charges in
approximately two hours. See the
CRD 1700
Cradle Quick Reference Guide
for more information.
Note: When the battery is fully charged, the cradle’s charging
LED lights green. On older CRD 1700 single slot and
modem cradles, the charging LED may not illuminate
green when the terminal’s battery is fully charged.
Using the Synchronization/Charging Cable to Charge the
Battery
1. Ensure the battery is installed in the terminal.
2. Insert the cable into the bottom of the terminal.
Synchronization/
Charging Cable