User Manual
Table Of Contents
- Introduction
- About This Guide
- Getting Started with the SPT 1700
- Installing the Battery
- Starting the SPT 1700
- Using the SPT 1700
- Scanning with the SPT 1700
- Initiate the Spectrum24 Network Connection
- Resetting Your SPT 1700 Terminal
- Attaching the Handstrap
- Maintaining the SPT 1700
- Troubleshooting
- SPT 1700 terminal does not turn on:
- Low battery warning after replacing the battery:
- No sound:
- SPT 1700 terminal turns itself off:
- SPT 1700 terminal doesn’t recognize my handwriting:
- Tapping the screen buttons or icons does not activate the corresponding feature:
- When I tap the icon, nothing happens:
- Beamed data does not transmit:
- When receiving beamed data an out of memory message appears:
- Your SPT 1700 unit does not accept scan input:
- Service Information
- Warranty
- Ergonomic Recommendations
- Regulatory Information
7
Quick Reference
Installing the Battery
To install the battery in your SPT 1700:
1. Open the latches on the battery cover and lift it away from the
SPT 1700.
2. Insert the lithium-ion battery in the battery compartment,
making sure it snaps into place.
3. Replace the battery cover and re-secure the latches.
Note: Be careful to position the battery latches completely
open while securing the battery cover on the terminal.
Latch
Latch