User Manual
Table Of Contents
- Introduction
- About This Guide
- Getting Started with the SPT 1700
- Installing the Battery
- Starting the SPT 1700
- Using the SPT 1700
- Scanning with the SPT 1700
- Initiate the Spectrum24 Network Connection
- Resetting Your SPT 1700 Terminal
- Attaching the Handstrap
- Maintaining the SPT 1700
- Troubleshooting
- SPT 1700 terminal does not turn on:
- Low battery warning after replacing the battery:
- No sound:
- SPT 1700 terminal turns itself off:
- SPT 1700 terminal doesn’t recognize my handwriting:
- Tapping the screen buttons or icons does not activate the corresponding feature:
- When I tap the icon, nothing happens:
- Beamed data does not transmit:
- When receiving beamed data an out of memory message appears:
- Your SPT 1700 unit does not accept scan input:
- Service Information
- Warranty
- Ergonomic Recommendations
- Regulatory Information
5
Quick Reference
3. Insert the SPT 1700 terminal in the cradle as shown:
The terminal’s battery is fully charged after approximately two
hours. You can also charge a terminal’s spare battery by inserting it
in the spare battery charging slot on the back of the cradle. Once
inserted, the spare battery will be fully charged after approximately
two hours. See the
SPT 1700 Cradle Quick Reference Guide
(p/n
70-37840-xx) for more information.
Using the Synchronization/Charging Cable to Charge the Battery
To charge the terminal’s battery using the Synchronization/
Charging Cable:
1. Make sure the battery is installed in the terminal. See
Install-
ing the Battery
on page 7 for instructions.