User Manual
Table Of Contents
- Introduction
- About This Guide
- Getting Started with the SPT 1700
- Installing the Battery
- Starting the SPT 1700
- Using the SPT 1700
- Scanning with the SPT 1700
- Initiate the Spectrum24 Network Connection
- Resetting Your SPT 1700 Terminal
- Attaching the Handstrap
- Maintaining the SPT 1700
- Troubleshooting
- SPT 1700 terminal does not turn on:
- Low battery warning after replacing the battery:
- No sound:
- SPT 1700 terminal turns itself off:
- SPT 1700 terminal doesn’t recognize my handwriting:
- Tapping the screen buttons or icons does not activate the corresponding feature:
- When I tap the icon, nothing happens:
- Beamed data does not transmit:
- When receiving beamed data an out of memory message appears:
- Your SPT 1700 unit does not accept scan input:
- Service Information
- Warranty
- Ergonomic Recommendations
- Regulatory Information
4
SPT 1700 Series
Getting Started with the SPT 1700
Before you can use your SPT 1700, perform the basic set up
procedures covered on the following pages. Specifically:
• Charge and Install the Battery
• Start the SPT 1700
• Initiate the Spectrum24 network connection (SPT 1740 only).
Charging the Battery
Before using your SPT 1700 for the first time, charge and install the
lithium-ion battery. The terminal’s battery can be charged using the
Cradle, the Synchronization/Charging Cable, or the Universal
Battery Charger (UBC). For instructions on using the UBC to charge
your batteries, see the Quick Reference Guide which came with
your UBC. Follow these same procedures to recharge the battery
when the terminal’s battery level is low.
Note: The battery included in the package (p/n 20-36098-01/
model number 1UF103450) must be used exclusively as
the power source for the SPT 1700 series, and should
not be used for any other purpose.
Using the Cradle to Charge the Battery
To charge the terminal’s battery using the CRD 1700 cradle:
1. Make sure the battery is installed in the terminal. See
Install-
ing the Battery
on page 7 for instructions.
2. Make sure the cradle is plugged into a wall outlet.