User Manual
Table Of Contents
- Introduction
- About This Guide
- Getting Started with the SPT 1700
- Installing the Battery
- Starting the SPT 1700
- Using the SPT 1700
- Scanning with the SPT 1700
- Initiate the Spectrum24 Network Connection
- Resetting Your SPT 1700 Terminal
- Attaching the Handstrap
- Maintaining the SPT 1700
- Troubleshooting
- SPT 1700 terminal does not turn on:
- Low battery warning after replacing the battery:
- No sound:
- SPT 1700 terminal turns itself off:
- SPT 1700 terminal doesn’t recognize my handwriting:
- Tapping the screen buttons or icons does not activate the corresponding feature:
- When I tap the icon, nothing happens:
- Beamed data does not transmit:
- When receiving beamed data an out of memory message appears:
- Your SPT 1700 unit does not accept scan input:
- Service Information
- Warranty
- Ergonomic Recommendations
- Regulatory Information
15
Quick Reference
Attaching the Handstrap
The SPT 1700 has an optional handstrap which increases comfort
when holding the terminal for extended periods of time. To attach
the handstrap to the back of the terminal:
1. Thread the round metal piece through the metal handstrap
connection on the back of the terminal.
2. Slide the flat metal piece into the handstrap connection on the
bottom of the terminal.
3. Adjust the velcro
®
strap to fit your hand.
Thread round metal
piece through this
connector
Slide flat metal piece up
and into this connector