User Manual
Table Of Contents
- Introduction
- About This Guide
- Getting Started with the SPT 1700
- Installing the Battery
- Starting the SPT 1700
- Using the SPT 1700
- Scanning with the SPT 1700
- Initiate the Spectrum24 Network Connection
- Resetting Your SPT 1700 Terminal
- Attaching the Handstrap
- Maintaining the SPT 1700
- Troubleshooting
- SPT 1700 terminal does not turn on:
- Low battery warning after replacing the battery:
- No sound:
- SPT 1700 terminal turns itself off:
- SPT 1700 terminal doesn’t recognize my handwriting:
- Tapping the screen buttons or icons does not activate the corresponding feature:
- When I tap the icon, nothing happens:
- Beamed data does not transmit:
- When receiving beamed data an out of memory message appears:
- Your SPT 1700 unit does not accept scan input:
- Service Information
- Warranty
- Ergonomic Recommendations
- Regulatory Information
12
SPT 1700 Series
Scanning with the SPT 1700
The SPT 1700 has an integrated laser bar code scanner which, if
your unit has been configured to use scanning input, allows you to
collect data by scanning bar codes.
To scan bar codes with the SPT 1700:
1. Start your scanning application.
1. Aim the scanner at the bar code.
2. Press either the right, left or center scan trigger. Make sure the
red scan beam covers the entire bar code. The green scan LED
lights and a beep sounds to indicate a successful decode.