User Manual
Table Of Contents
- Introduction
- About This Guide
- Getting Started with the SPT 1700
- Installing the Battery
- Starting the SPT 1700
- Using the SPT 1700
- Scanning with the SPT 1700
- Initiate the Spectrum24 Network Connection
- Resetting Your SPT 1700 Terminal
- Attaching the Handstrap
- Maintaining the SPT 1700
- Troubleshooting
- SPT 1700 terminal does not turn on:
- Low battery warning after replacing the battery:
- No sound:
- SPT 1700 terminal turns itself off:
- SPT 1700 terminal doesn’t recognize my handwriting:
- Tapping the screen buttons or icons does not activate the corresponding feature:
- When I tap the icon, nothing happens:
- Beamed data does not transmit:
- When receiving beamed data an out of memory message appears:
- Your SPT 1700 unit does not accept scan input:
- Service Information
- Warranty
- Ergonomic Recommendations
- Regulatory Information
9
Quick Reference
3. Tap the exact center of each target that appears on the screen
with the tip of the stylus.
If, at any time, you need to recalibrate the digitizer, open the
Preferences application, tap on the top right corner of the screen,
and select the digitizer option from the pull down menu.
Using the SPT 1700
Using the Power Button/Backlight Control
The power button turns the SPT 1700 on and off. This button also
serves as your backlight control for low-light conditions. With the
unit on, press and hold the power button for approximately 2
seconds to turn the backlight on and off. When the backlight is on,
the screen text displays in reverse video.