User Manual
Table Of Contents
- About This Guide
- Introduction
- Getting Started
- Installation and Communication
- Administrator Console
- Maintenance and Troubleshooting
- Specifications
XR400 RFID Reader Integrator Guide4-6
Setting Date and Time
To set the reader’s date and time:
1. Select Date/Time in the Communication window.
Figure 4-3. System Time Management Window
2. To synchronize the reader’s clock with a particular SNTP server, enter the server’s address in the SNTP Server Address: field
and click Set SNTP Parameters.
SNTP (Simple Network Time Protocol) is an Internet standard protocol (built on TCP/IP) that assures accurate
synchronization to the millisecond of computer clock times in a network of computers.
3. To set the reader’s system time manually, use the drop-down lists to select units of time, then click Set Date and Time.
4. Use the Time Zone: drop-down list to set the reader’s time zone, then click Set Time Zone.