User's Manual

Doc #: PD001743A01 Rev. B.0
Symbol Solutions, Inc. Page 19 of 22
Symbol Confidential Restricted
 Locked and signed software does not allow access to commands to modify radio type.
Control panel in windows can only read the radio type.
 Password protection. This is added security beyond the locked and signed software.
 Specialized commands to change radio types, which are only available in
manufacturing and authorized service depots.
11.4 Radio Protocol
Drivers are available supporting the following features:
 Compatible with Symbol’s NarrowBand Polling Protocol Cellular only. Non-cellular
modes not be supported.
 Transparent roaming and power saving modes (terminals only). 9130/9140 2L
modulation base stations not be supported
 RMAN API interface supported by the TekTerm application (terminals only)
 Radio protocol diagnostic information (viewable via TekTerm for terminals)
11.5 Radio Calibration data
All calibration parameters are calibrated and tested during manufacturing then locked out from
end customers.
12.0 Host Software
12.1 Radio Tests
RTest command line utility allow developers and approval testers to perform the following radio
tests:
 Channel (frequency) selection
 Transmit long
 Transmit test
 Receive Test (BER)
12.2 Configuration and Tuning
RTest allows developer, manufacturing and approval tester to configure all necessary radio
settings such as data rate, modulation type and operating frequency.
End user shall not be able to modify any approval related parameters of the radio module.
This is done by 3 layers of protection described in section 11.3 of this document.