User's Manual
Table Of Contents
- 1.0 Revision History
- 2.0 Introduction
- 3.0 General Description
- 4.0 References
- 5.0 Product Level Specifications
- 6.0 Applicable Approvals
- 7.0 Approvals and Safety Summary
- 8.0 General
- 1.0
- 1.0
- 1.0
- 1.0
- 1.0
- 1.0
- 1.0
- 9.0 Interfaces
- 10.0 Electrical Characteristics
- 11.0 Software Features and Functions
- 12.0 Host Software
- 13.0 Mechanical & Ergonomic Specifications
- 1.0
- 14.0 Appendices
Doc #: PD001743A01 Rev. B.0
Symbol Solutions, Inc. Page 12 of 22
Symbol Confidential Restricted
7.1 FCC Information to Users
For Class B Unintentional Radiators:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one of more of
the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
7.2 Warning to Users
Changes or modifications not expressly approved by Symbol Technologies Inc, the party
responsible for compliance, may void the user's authority to operate the equipment.
7.3 FCC & IC RF Exposure Warning
A separation Distance of at least 22 cm is required to be maintained between the user and the
antenna when the antenna with the gain of less than or equal to 2 dBi is used for Mobile
Application.
A separation distance of at least 70 cm is required to be maintained between the user and the
antenna when the antenna with the gain of less than or equal to 12 dBi is used for Fixed base
application.
VH10 collocation evaluation is based on 0 dBi gain antenna requiring a separation distance of at
least 20 cm.
7.4 Labeling Requirement for Radio Module
A label is affixed to the radio module with the following information:
Symbol Technologies Inc UHF Radio, Model RA1202
FCC ID: H9PRA1202