User Manual

Installation for MS-DOS
Setup the WaveLAN Parameters
WaveLAN IEEE 802.11 PC Card User’s Guide D-13
4b Receive All Multicasts This parameter specifies whether the
station must receive all multicast frames
when in Power Management mode.
Valid Values:
■ Y - Yes, receive all Mulitcasts (= default)
■ N - No, do not receive all Multicast
When this parameter is enabled, the
WaveLAN station will wake up at regular
intervals to receive the multicast frames.
Although enabling this option may yield less
optimal power savings, you are advised to
leave this parameter enabled when using
your computer in regular networking
environments.
If 4a Card Power Management is disabled,
this parameter will be ignored.
5 AP Density Parameter that controls the Roaming
sensitivity of your computer (must be set
according to the settings of the
WavePOINT-II access points).
Valid Values:
1. Low Density (default)
2. Medium Density
3. High Density
Table D-2 WaveLAN DOS ODI Driver Parameters—Continued