User's Manual
Table Of Contents
- Introduction
- Parts of the PPT 2800
- Parts of the PPT 2800 (continued)
- Installing the SIM Card (PPT 2837 Only)
- Installing Batteries
- Charging the Battery
- Attaching the Handstrap
- Starting the PPT 2800
- Using the PPT 2800
- Initiating a Network Connection
- Resetting Your PPT 2800 Terminal
- Maintaining the PPT 2800
- Troubleshooting
- END-USER LICENSE AGREEMENT
- Ergonomic Recommendations
- Regulatory Information
11
Quick Reference
Starting the PPT 2800
Press the red power button to start the terminal. If the terminal
does not power on, perform a hard reset. See Performing a Hard
Reset on page 22.
As the terminal initializes its unique Flash File system, the Symbol
splash screen displays for about a minute.
When the Welcome screen appears, tap anywhere on the screen
to continue to the Align screen. Note that these screens also
appear every time you perform a hard reset.
Aligning the Screen
To align your PPT 2800 so the cursor on the touch screen aligns
with the tip of your stylus:
1. If necessary, adjust the contrast (monochrome LCD only) on
the PPT 2800 so the screen is readable. See Controlling the
Backlight on page 12.
2. Remove the stylus from its storage silo on the back of the
PPT 2800.
Power
Button