User Manual
Table Of Contents
- Introduction
- About This Guide
- Parts of the PPT 2700
- Parts of the PPT 2700 (continued)
- Installing Batteries
- Recharging the Battery
- Starting the PPT 2700
- Using the PPT 2700
- Resetting Your PPT 2700 Terminal
- Maintaining the PPT 2700
- Troubleshooting
- PPT 2700 terminal does not turn on:
- No sound:
- PPT 2700 terminal turns itself off:
- PPT 2700 terminal doesn’t recognize my handwriting:
- Tapping the screen buttons or icons does not activate the corresponding feature:
- A message appears stating that your PPT 2700 terminal memory is full:
- Beamed data does not transmit:
- When receiving beamed data an out of memory message appears:
- Your PPT 2700 unit does not accept scan input:
- Regulatory Information
7
Quick Reference
2. Plug the power cable into a wall outlet and plug the other end
into the battery charging receptacle on the side of the Synchro-
nization Cable.
Starting the PPT 2700
After installing and charging the battery, start the terminal by
pressing the red power button. If the terminal does not power on,
perform a hard reset. See
Performing a Hard Reset
on page 13.
Battery Charging
Receptacle
Power
Button