User Manual
Table Of Contents
- Introduction
- About This Guide
- Parts of the PPT 2700
- Parts of the PPT 2700 (continued)
- Installing Batteries
- Recharging the Battery
- Starting the PPT 2700
- Using the PPT 2700
- Resetting Your PPT 2700 Terminal
- Maintaining the PPT 2700
- Troubleshooting
- PPT 2700 terminal does not turn on:
- No sound:
- PPT 2700 terminal turns itself off:
- PPT 2700 terminal doesn’t recognize my handwriting:
- Tapping the screen buttons or icons does not activate the corresponding feature:
- A message appears stating that your PPT 2700 terminal memory is full:
- Beamed data does not transmit:
- When receiving beamed data an out of memory message appears:
- Your PPT 2700 unit does not accept scan input:
- Regulatory Information
6
PPT 2700 Series
charged after approximately 2 1/2 hours. See the
PPT 2700 Cradle
Quick Reference Guide
(p/n 70-37807-xx) for more information.
The Spare Battery Charge LED turns red to indicate charging, then
green when the battery is fully charged. The battery is fully charged
after approximately 2 1/2 hours.
Using the Synchronization Cable to Recharge the
Battery
To recharge the terminal’s battery using the Synchronization Cable:
1. Insert the cable into the bottom of the terminal.
Spare Battery
Charge LED
Synchronization Cable