User Manual
Table Of Contents
- Introduction
- About This Guide
- Parts of the PPT 2700
- Parts of the PPT 2700 (continued)
- Installing Batteries
- Recharging the Battery
- Starting the PPT 2700
- Using the PPT 2700
- Resetting Your PPT 2700 Terminal
- Maintaining the PPT 2700
- Troubleshooting
- PPT 2700 terminal does not turn on:
- No sound:
- PPT 2700 terminal turns itself off:
- PPT 2700 terminal doesn’t recognize my handwriting:
- Tapping the screen buttons or icons does not activate the corresponding feature:
- A message appears stating that your PPT 2700 terminal memory is full:
- Beamed data does not transmit:
- When receiving beamed data an out of memory message appears:
- Your PPT 2700 unit does not accept scan input:
- Regulatory Information
5
Quick Reference
Charge the battery in the terminal for about 2 1/2 hours before
initial use.
Recharging the Battery
When battery voltage is low, a warning message appears indicating
the battery needs to be recharged. You can recharge the terminal’s
battery using either the CRD 2700 Cradle or the Synchronization
Cable.
Using the Cradle to Recharge the Battery
To recharge the terminal’s battery using the CRD 2700 cradle:
1. Make sure the cradle is plugged into a wall outlet.
2. Insert the PPT 2700 terminal in the cradle.
3. The Terminal Charge LED turns red to indicate charging, then
green when the battery is fully charged. The terminal’s battery
is fully charged after approximately 2 1/2 hours.
Charging a Spare Battery
You can also recharge a terminal’s spare battery by inserting it in the
spare battery charging slot in the back of the cradle, oriented so the
contacts are facing down and towards the back of the cradle. Press
the battery down into the slot until firmly seated. The battery is fully
Terminal Charge LED