User Manual
Table Of Contents
- Introduction
- About This Guide
- Parts of the PPT 2700
- Parts of the PPT 2700 (continued)
- Installing Batteries
- Recharging the Battery
- Starting the PPT 2700
- Using the PPT 2700
- Resetting Your PPT 2700 Terminal
- Maintaining the PPT 2700
- Troubleshooting
- PPT 2700 terminal does not turn on:
- No sound:
- PPT 2700 terminal turns itself off:
- PPT 2700 terminal doesn’t recognize my handwriting:
- Tapping the screen buttons or icons does not activate the corresponding feature:
- A message appears stating that your PPT 2700 terminal memory is full:
- Beamed data does not transmit:
- When receiving beamed data an out of memory message appears:
- Your PPT 2700 unit does not accept scan input:
- Regulatory Information
4
PPT 2700 Series
Installing Batteries
Before using your PPT 2700, you must install a lithium-ion battery.
The battery fits behind the battery door on the back of the PPT
2700.
To install the battery in your PPT 2700:
1. Open the latches on the battery door and lift the battery door
away from the PPT 2700.
2. Insert the lithium-ion battery in the battery compartment with
the battery tether positioned properly (as shown below), mak-
ing sure the battery snaps into place.
3. Replace the battery cover and press down firmly on the cover
while re-securing the latches.
Latch
Latch
Tethe r