User Manual
Table Of Contents
- Introduction
- About This Guide
- Parts of the PPT 2700
- Parts of the PPT 2700 (continued)
- Installing Batteries
- Recharging the Battery
- Starting the PPT 2700
- Using the PPT 2700
- Resetting Your PPT 2700 Terminal
- Maintaining the PPT 2700
- Troubleshooting
- PPT 2700 terminal does not turn on:
- No sound:
- PPT 2700 terminal turns itself off:
- PPT 2700 terminal doesn’t recognize my handwriting:
- Tapping the screen buttons or icons does not activate the corresponding feature:
- A message appears stating that your PPT 2700 terminal memory is full:
- Beamed data does not transmit:
- When receiving beamed data an out of memory message appears:
- Your PPT 2700 unit does not accept scan input:
- Regulatory Information
18
PPT 2700 Series
• Low Voltage Directive 73/23/EEC
Applicable Standards
• EN 55022:1998, Limits and Methods of Measurement of Radio Disturbance
Characteristics of Information Technology Equipment
• EN 55024:1998; Information Technology equipment - Immunity characteristics -
Limits and methods of measurement
• IEC 1000-4-2:1995; Electromagnetic compatibility (EMC);Part 4:Testing and
measurement techniquies;Section 4.2:Electrostatic discharge immunity test
• IEC 1000-4-3:1997; Electromagnetic Compatibility (EMC);Part 4:Testing and
measurement techniques; Section 3. Radiated, radio frequency, electomagnetic
field immunity test.
• IEC 1000-4-4:1995; Electomagnetic compatibility (EMC); Part 4: Testing and
measurement techniques;Section 4:Testing electrical fast transient,/Burst immu-
nity.
• IEC1000-4-5:1995; Electromagnetic compatibility (EMC), Part 4: Testing and
measurement techniques;Section 5: Surge Immunity
• IEC 1000-4-6:1996; Electromagnetic compatibility (EMC), Part 4:Testing and
measurement techniques; Section 6: Immunity to conducted disturbances,
induced by radio frequency fields.
• IEC 1000-4-11:1994; Electromagnetic compatibility (EMC), Part 4: Testing and
measurement techniques; Section 11: Voltage Dips, Short Interruptions, and Volt-
age Variations.
• EN 60 950 + A1+A2+A3+A4+A11 - Safety of Information Technology Equip-
ment Including Electrical Business Equipment
• EN 60 825-1 (EN 60 825) - Safety of Devices Containing Lasers
Laser Devices
Symbol products using lasers comply with US 21CFR1040.10, and IEC825-1:1993,
EN60825-1:1994+A11:1996. The laser classification is marked on one of the labels on
the product.
Class 1 Laser devices are not considered to be hazardous when used for their intended
purpose. The following statement is required to comply with US and international
regulations:
Caution: Use of controls, adjustments or performance of procedures other than those
specified herein may result in hazardous laser light exposure.
Class 2 laser scanners use a low power, visible light diode. As with any very bright light
source, such as the sun, the user should avoid staring directly into the light beam.
Momentary exposure to a Class 2 laser is not known to be harmful.