User Manual
Table Of Contents
- Introduction
- About This Guide
- Parts of the PPT 2700
- Parts of the PPT 2700 (continued)
- Installing Batteries
- Recharging the Battery
- Starting the PPT 2700
- Using the PPT 2700
- Resetting Your PPT 2700 Terminal
- Maintaining the PPT 2700
- Troubleshooting
- PPT 2700 terminal does not turn on:
- No sound:
- PPT 2700 terminal turns itself off:
- PPT 2700 terminal doesn’t recognize my handwriting:
- Tapping the screen buttons or icons does not activate the corresponding feature:
- A message appears stating that your PPT 2700 terminal memory is full:
- Beamed data does not transmit:
- When receiving beamed data an out of memory message appears:
- Your PPT 2700 unit does not accept scan input:
- Regulatory Information
13
Quick Reference
Performing a Hard Reset
A hard reset also restarts your PPT 2700 terminal, but erases all
stored records and entries.
Therefore, never perform a hard reset
unless a soft reset does not solve your problem.
Note: You can restore any data previously synchronized with
your computer during the next ActiveSync operation.
See the
PPT 2700 Cradle Quick Reference Guide
or the
PPT 2700 Product Reference Guide.
To perform a hard reset:
1. Remove the battery cover.
2. While holding down the Function button, use the stylus (or
similar object
without
a sharp tip) to gently press the reset but-
ton.
3. Replace the battery cover and press the Power button.
4. The calibration screen appears.
Note: With a hard reset, Formats Preferences and other set-
tings are restored to their factory default settings.
Reset
Button
Function
Button