User Manual
Table Of Contents
- Introduction
- About This Guide
- Parts of the PPT 2700
- Parts of the PPT 2700 (continued)
- Installing Batteries
- Recharging the Battery
- Starting the PPT 2700
- Using the PPT 2700
- Resetting Your PPT 2700 Terminal
- Maintaining the PPT 2700
- Troubleshooting
- PPT 2700 terminal does not turn on:
- No sound:
- PPT 2700 terminal turns itself off:
- PPT 2700 terminal doesn’t recognize my handwriting:
- Tapping the screen buttons or icons does not activate the corresponding feature:
- A message appears stating that your PPT 2700 terminal memory is full:
- Beamed data does not transmit:
- When receiving beamed data an out of memory message appears:
- Your PPT 2700 unit does not accept scan input:
- Regulatory Information
12
PPT 2700 Series
The scan beam does not have to be
perfectly
parallel with the top
and bottom of the symbol (up to a 4
o
tilt will work).
Resetting Your PPT 2700 Terminal
If your PPT 2700 terminal stops responding to input from buttons
or the screen, you must reset it.
Performing a Soft Reset
A soft reset restarts the terminal and saves all stored records and
entries.
Note: Files that remain open during a soft reset may not be
retained.
To perform a soft reset, hold down both the up and down scroll
buttons, then press the App 4 button.
Up & Down
Scroll Buttons
App 4 Button