User Manual
Table Of Contents
- Introduction
- About This Guide
- Parts of the PPT 2700
- Parts of the PPT 2700 (continued)
- Installing Batteries
- Recharging the Battery
- Starting the PPT 2700
- Using the PPT 2700
- Resetting Your PPT 2700 Terminal
- Maintaining the PPT 2700
- Troubleshooting
- PPT 2700 terminal does not turn on:
- No sound:
- PPT 2700 terminal turns itself off:
- PPT 2700 terminal doesn’t recognize my handwriting:
- Tapping the screen buttons or icons does not activate the corresponding feature:
- A message appears stating that your PPT 2700 terminal memory is full:
- Beamed data does not transmit:
- When receiving beamed data an out of memory message appears:
- Your PPT 2700 unit does not accept scan input:
- Regulatory Information
9
Quick Reference
4. Press the Action button to continue, or the Exit button to can-
cel.
5. Follow the directions on the screen.
Using the PPT 2700
Using the Power Button
The power button is on the lower left-hand side of the terminal.
Press it to turn the PPT 2700 on and off.
Controlling the Contrast/Backlight
The Function button, shown below, allows you to adjust the
contrast of the screen and control the backlight.
To adjust the contrast:
1. Press and hold the Function button.
2. Press the “up” scroll button at the top of the terminal to dark-
en the screen, or the “down” scroll button to lighten the
screen.
Action Button
Exit Button
Function Button
Power Button