User Manual
Table Of Contents
- Introduction
- About This Guide
- Parts of the PPT 2700
- Parts of the PPT 2700 (continued)
- Installing Batteries
- Recharging the Battery
- Starting the PPT 2700
- Using the PPT 2700
- Resetting Your PPT 2700 Terminal
- Maintaining the PPT 2700
- Troubleshooting
- PPT 2700 terminal does not turn on:
- No sound:
- PPT 2700 terminal turns itself off:
- PPT 2700 terminal doesn’t recognize my handwriting:
- Tapping the screen buttons or icons does not activate the corresponding feature:
- A message appears stating that your PPT 2700 terminal memory is full:
- Beamed data does not transmit:
- When receiving beamed data an out of memory message appears:
- Your PPT 2700 unit does not accept scan input:
- Regulatory Information
8
PPT 2700 Series
Calibrating the Screen
The first time you start your PPT 2700 (and whenever the terminal
is cold-booted) the calibration screen appears. This section
describes how to calibrate your PPT 2700 so the cursor on the touch
screen aligns with the tip of your stylus.
Note: If your PPT 2700 unit came loaded with another soft-
ware application, the calibration screen may not appear.
To calibrate your PPT 2700:
1. If necessary, adjust the contrast on the PPT 2700 so the screen
is clear and readable. See
Controlling the Contrast/Backlight
on page 9 for instructions.
2. Remove the stylus from its storage silo on the back of the PPT
2700.
3. Tap the center of each target that appears on the screen with
the tip of the stylus.
Tap the center of the target with the
stylus. Repeat as the target moves
around the screen.