User Manual
Table Of Contents
- Introduction
- Equipment Supplied
- Save the shipping container for storing or shipping. Inspect all your equipment for damage. If an...
- Related Documentation
- Parts of the Cradle
- Connecting To The Host
- Daisy-Chaining
- Wall Mounting
- Inserting Phaser in the Cradle
- Sending Data to Host Computer
- Recharging the Battery in the Phaser
- Indicator LED
- Troubleshooting
- Cleaning
- Regulatory Information
- Service Information
- Warranty
Preliminary
5
Quick Reference
2. Insert the cable from the host computer into COM 1 and the
cable to the other cradles, if any, into COM 2.
Daisy-Chaining
Note: The cradle supports daisy-chaining when connected to a serial host
and not when using Synapse interfaces.
To daisy-chain two or more cradles together, connect COM 1 of the
first cradle to the host and COM 2 to COM 1 of the second cradle.
Then connect COM 2 of the second cradle to COM 1 of the third
cradle. You can daisy-chain up to 12 cradles to one host in this
manner.
Wall Mounting
Before wall-mounting the cradle, the scanner support tab must be
changed from the desk-mount position to the wall-mount position.
1. Lift the scanner support tab out of the top part of the cradle
and replace it in the wall-mount position, as shown:
Desk Mount
Wall Mount