User's Manual

Section 2: Installing the PCS Connection Card
2A: Installation on Notebook PCs 19
Installing the PCS Connection Card driver.
1. Attach the antenna to the PCS Connection Card and, with
the label facing up, carefully insert the card into your PC
Card slot. Windows should detect that a new device has
been inserted and launch the wizard that guides you
through the driver installation.
2. Select Install from a list or specific location (Advanced) on
the first window of the Found New Hardware Wizard and
click Next to proceed.
3. Select the Search for the best driver in these locations radio
button, and the Include this location in the search check
box, then enter d:\Drivers\WinXP where d is the drive letter
of your CD-ROM drive. Click Next to proceed to the next
window.
4. If a warning appears stating that PCS Connection Card
has not passed Windows Logo testing, click Continue
Anyway.
5. Click Finish and repeat steps 1 to 4 as prompted.
6. Click OK when prompted that the card has been
successfully installed.
On completion of this step, the PCS Connection Manager
Software and the PCS Connection Card driver are installed
and you can proceed to activate your card. See “Activating
Your PCS Connection Card” on page 20.
Tip: A driver is software that forms the interface between a device (such
as the PCS Connection Card) and the operating system on your PC (such
as Windows XP).
Inserting and Removing the PCS Connection
Card
Inserting the PCS Connection Card
Before you insert the PCS Connection Card, you must first
install the Wireless Connection Manager Software. Once you
have completed the installation procedure, you may insert
your card into your computer’s PC Card slot. The Sprint label
should be facing up, and the 68-pin connector, located at the