Quick Reference Guide
Table Of Contents
- Introduction
- About This Guide
- Accessories
- Parts of the Terminal
- Parts of the Terminal (continued)
- Installing the SIM Card
- Inserting a Compact Flash Storage Card (PDT 8037 only)
- Removing a Compact Flash Storage Card
- Inserting an MMC/SD Storage Card
- Removing an MMC/SD Storage Card
- Installing Batteries
- Charging the Battery
- Starting the Terminal
- Adjusting the Backlight
- Using a Headset
- Using the Keyboard
- Using the Stylus
- Today Screen
- Navigation Bar and Command Bar
- Input Methods
- Scanning with the Terminal
- Resetting Your Terminal
- Host Communications
- LED Indicators
- Maintaining the Terminal
- Troubleshooting
- END-USER LICENSE AGREEMENT
- Regulatory Information
- Ergonomic Recommendations
- Laser Devices
- Power Supply
- FCC RF Exposure Guidelines
- GSM Regulatory Warnings
- Radio Frequency Interference Requirements
- Radio Frequency Interference Requirements - FCC
- Radio Frequency Interference Requirements - Canada
- Marking and European Economic Area (EEA)
- Radio Modules
- Statement of Compliance
6
PDT 80XX WWAN
Installing the SIM Card
1. Slide the latches on the battery door up and lift the battery
door away from the terminal. If the battery is installed, re-
move it (see Installing Batteries on page 9).
2. Slide the metal clip on the SIM card-
holder door to the left to release the
SIM cardholder.
3. Lift the cardholder door to an upright
position
4. Insert the card between the cardholder
body and the metal clip; be sure the
beveled corner of the SIM card is on
the top left.
5. Close the cardholder door (with the
contact area of the card facing down).
6. Slide the metal clip to the right to lock it
in place.
7. Reinsert the battery and replace the
battery door (see Installing Batteries on
page 9).
SIM Card
Contact Area
For Internal Use Only