User's Manual
Table Of Contents
- Introduction
- About This Guide
- Accessories
- Parts of the PDT 7500
- Installing New or Recharged Batteries
- Removing the Battery from the Terminal
- Charging the Battery in the Terminal
- Operating the PDT 7500
- Host Communications
- Using the Touch Screen
- Troubleshooting
- Pin-Outs
- Ergonomic Recommendations
- Regulatory Information
- END-USER LICENSE AGREEMENT FOR MICROSOFT SOFTWARE
- Warranty
- Service Information
5
Quick Reference
Installing New or Recharged Batteries
Caution: To ensure proper terminal operation, use ONLY the
Symbol Li-Ion battery in the PDT 7500.
To install a new or recharged Li-Ion
battery:
1. Hook the base of the new bat-
tery in the top of the battery
compartment, then press the
into place.
2. Slide the battery latch to se-
cure the battery.
If the battery latch is not closed, do not operate the terminal,
otherwise data may be lost.
Caution: Do not expose the battery to temperatures in excess of
140°F (60°C). Do not disassemble, incinerate, or short
circuit the battery.
Removing the Battery
from the Terminal
To remove the Li-Ion battery from
the terminal:
1. Suspend the terminal’s power.
2. Slide the battery release switch
towards the top of the termi-
nal until the lock releases.