Reference Guide
Table Of Contents
- About This Guide
- Chapter 1 Getting Started
- Chapter 2 Accessories Setup
- Chapter 3 Batch and Spectrum One Terminal Setup
- Chapter 4 Spectrum24 RF Terminal Setup
- Chapter 5 Operating the PDT 6800 Series
- Chapter 6 Maintaining the Terminal
- Chapter 7 Error Recovery and Troubleshooting
- Appendix A Null Modem Pin-outs
- Appendix B Keyboard Layouts
- Appendix C Communications Status Codes
- Appendix D Specifications
- Appendix E Boot-Up Quick Reference
- Appendix F 2D Scanner Drivers and Applications
- Numerics
- A
- B
- C
- D
- E
- F
- I
- K
- L
- M
- N
- P
- R
- S
- T
- U
- W
7-13
Error Recovery and Troubleshooting
!
Check to see that you are scanning from the proper distance.
Your terminal operates but scanned data is not displayed correctly?
!
Check the system power.
!
Check that the communications parameters (baud rate, parity, stop bits, etc.) are set
properly for the receiving device.
The laser does not activate?
!
You may have exceeded the allowable amount of scanning activity within the limits
of your laser class of operation; in this case, wait for a short interval before scanning
again.
!
You may be scanning in an inappropriately hot environment. If so, remove the
equipment from the environment or allow the laser to cool down.