Reference Guide
Table Of Contents
- About This Guide
- Chapter 1 Getting Started
- Chapter 2 Accessories Setup
- Chapter 3 Batch and Spectrum One Terminal Setup
- Chapter 4 Spectrum24 RF Terminal Setup
- Chapter 5 Operating the PDT 6800 Series
- Chapter 6 Maintaining the Terminal
- Chapter 7 Error Recovery and Troubleshooting
- Appendix A Null Modem Pin-outs
- Appendix B Keyboard Layouts
- Appendix C Communications Status Codes
- Appendix D Specifications
- Appendix E Boot-Up Quick Reference
- Appendix F 2D Scanner Drivers and Applications
- Numerics
- A
- B
- C
- D
- E
- F
- I
- K
- L
- M
- N
- P
- R
- S
- T
- U
- W
7-12
PDT 6800 Series Product Reference Guide
The display is updated for every 1024 bytes (1 KB) of memory.
4. When the transmission completes or aborts, the terminal displays the transmission
status screen:
Memory Transfer
Status 0000
A status of 0000 (all zeros) indicates that the transfer was successful. Any other
status indicates failure. Refer to Appendix C, Communications Status Codes, for the
status codes which indicate the source of the error.
End Communications
To return to the Command Mode Main Menu, press <CLEAR>. Take whatever corrective
action is necessary and reboot the terminal.
Internal Modem Problems
If you are having difficulties with your internal modem, please check the following before
returning your product:
!
Connection to the telephone network is correct.
!
Any necessary special requirements such as dialing 9 and ignoring dial tone have
been considered in the event of using a PBX.
!
Firmware settings described in the Series 3000 Application Programmer’s Guide have
been configured correctly.
Scanning Problems
What If...
Nothing happens when you follow the operating instructions?
!
Check the system power.
!
Verify that the scanner is programmed to read the symbology you are trying to read.
!
Try scanning a test symbol of the symbology you are trying to read.
!
Check the bar code to ensure that it is not defaced. A defaced bar code may not be
readable.