Reference Guide

Table Of Contents
7-11
Error Recovery and Troubleshooting
EMS 0000 010
Correct? <ENT>
If the values are correct, press <ENTER>. If the values are not correct, press
<CLEAR> to clear the fields and select new values.
8. Specify the baud rate. Use the UpArrow and DownArrow to scroll through the list
of baud rates until the correct rate is displayed and press <ENTER>.
Note:
Flow control may be necessary at 38400 bps and higher.
9. Specify the data bits. Press <7> or <8>, or use UpArrow and DownArrow to display
the values 7 or 8, and press <ENTER>.
Note: If you select 8 data bits, the program selects No parity and skips the
next screen.
10. Specify parity type. Use UpArrow and DownArrow to display a parity option, or
press the first letter of a parity option (Even, Odd, None, Space, or Mark) and press
<ENTER>.
11. Set flow control. Use UpArrow and DownArrow to display the flow control options,
or press the first letter of an option (None, Xon/Xoff, or RTS/CTS) and press
<ENTER>.
Start Communications
1. The terminal is ready to send the data to the host PC and displays:
Comm Parameters
Start? <ENT>
2. Verify that the host is ready to receive data.
3. Press <ENTER> on the terminal.
While data is being transferred, the terminal displays a report of the 1 KB range being
transferred:
Memory Transfer
Sending: XXXX