Reference Guide

7-10
PDT 6800 Series Product Reference Guide
Te r m i n a l
1. Boot the terminal to Command Mode (refer to Chapter 5, Operating the PDT 6800
Series for the appropriate key sequence).
2. Select the Memory Transfer function from the Command Mode menu. Use UpArrow
or DownArrow to scroll through the Command Mode options until Memory
Transfer is displayed, then press <ENTER>.
3. Select the range of memory to transfer by pressing the first letter of the desired range
(All, Range, or None), or use the UpArrow or DownArrow and press <ENTER>.
If you select All, the program skips to the range verification screen (step 7, page 10).
If you select Range, the screen displays:
RAM
Use Arrow Keys
Start End
00000 9FFFF
4. Specify a range of RAM by setting the Start and End addresses.
" Use RightArrow and LeftArrow to move the cursor to the digit to be changed
" Use UpArrow and DownArrow to change the values.
Type a range and press <ENTER>.
5. Specify a range of NVM to transfer. Choose All or None.
6. If the system has EMS installed, it prompts for the range to transfer; otherwise, it
skips this screen:
EMS
Use arrow keys
Start End
The range is specified in page numbers (16 KB per page). Use RightArrow and
LeftArrow to move between the Start and End values. Use UpArrow and
DownArrow to change the page number value.
Set the range and press <ENTER>.
7. The terminal displays a range verification screen. For example:
RAM 0000 3FFF
NVM D510 DFFF