Reference Guide
Table Of Contents
- About This Guide
- Chapter 1 Getting Started
- Chapter 2 Accessories Setup
- Chapter 3 Batch and Spectrum One Terminal Setup
- Chapter 4 Spectrum24 RF Terminal Setup
- Chapter 5 Operating the PDT 6800 Series
- Chapter 6 Maintaining the Terminal
- Chapter 7 Error Recovery and Troubleshooting
- Appendix A Null Modem Pin-outs
- Appendix B Keyboard Layouts
- Appendix C Communications Status Codes
- Appendix D Specifications
- Appendix E Boot-Up Quick Reference
- Appendix F 2D Scanner Drivers and Applications
- Numerics
- A
- B
- C
- D
- E
- F
- I
- K
- L
- M
- N
- P
- R
- S
- T
- U
- W
7-2
PDT 6800 Series Product Reference Guide
Error Messages
If ERR3000 is loaded in the system configuration, the terminal displays the following
messages to indicate error conditions that affect system performance. A message is usually
accompanied by one or more beeps, after which the system returns to its previous status.
The application can change the actual wording of the messages or disable messages. The
messages listed in Table 7-1 are representative. Refer to the Series 3000 Application
Programmer's Guide or your application guide for additional information.
Table 7-1. Error Messages
Message Explanation
Double Key Error Two or more keys were pressed at the same time. This does not
include boot sequences described in Chapter 5, Operating the
PDT 6800 Series.
Low Battery The battery pack should be recharged or replaced as soon as
possible.
Dead Battery Replace or recharge the battery pack immediately. This message
is programmable, so it may be worded differently. See your
application guide. After this message is displayed, the terminal
shuts itself off. You may not be able to power it on again until
the battery pack is charged.
Power Fault The last terminal power off was caused by a power failure.
Possible causes of a power failure include:
• the battery pack is removed with the terminal on
• the terminal is dropped
• the batteries lose power suddenly
• the terminal displays a low battery power error message, and
you attempt to power the terminal on without recharging or
replacing the batteries.