Reference Guide
Table Of Contents
- About This Guide
- Chapter 1 Getting Started
- Chapter 2 Accessories Setup
- Chapter 3 Batch and Spectrum One Terminal Setup
- Chapter 4 Spectrum24 RF Terminal Setup
- Chapter 5 Operating the PDT 6800 Series
- Chapter 6 Maintaining the Terminal
- Chapter 7 Error Recovery and Troubleshooting
- Appendix A Null Modem Pin-outs
- Appendix B Keyboard Layouts
- Appendix C Communications Status Codes
- Appendix D Specifications
- Appendix E Boot-Up Quick Reference
- Appendix F 2D Scanner Drivers and Applications
- Numerics
- A
- B
- C
- D
- E
- F
- I
- K
- L
- M
- N
- P
- R
- S
- T
- U
- W
6-5
Maintaining the Terminal
Figure 6-2. Installing the Battery Pack
Battery Charging Tips
For maximum capacity and battery life, follow these helpful hints:
Do
!
Charge at temperatures between 0°C and 38°C (32°F to 100°F); 21°C (70°F) is
preferred
!
Recharge as soon as you see the “Low Battery” message
!
Save your data and program on another terminal or another medium if you plan to
store your terminal without the primary battery pack
!
Store batteries at room temperature of 21°C (70°F) or cooler
!
Recharge the NiCd battery pack after storage.
Don't
!
Store or recharge primary batteries at temperatures below 0°C (32°F) or above 38°C
(100°F)
!
Judge a battery's charge level by measuring its voltage; voltage does not indicate
charge level.
Orient
Slide
Push to
Lock