Reference Guide
Table Of Contents
- About This Guide
- Chapter 1 Getting Started
- Chapter 2 Accessories Setup
- Chapter 3 Batch and Spectrum One Terminal Setup
- Chapter 4 Spectrum24 RF Terminal Setup
- Chapter 5 Operating the PDT 6800 Series
- Chapter 6 Maintaining the Terminal
- Chapter 7 Error Recovery and Troubleshooting
- Appendix A Null Modem Pin-outs
- Appendix B Keyboard Layouts
- Appendix C Communications Status Codes
- Appendix D Specifications
- Appendix E Boot-Up Quick Reference
- Appendix F 2D Scanner Drivers and Applications
- Numerics
- A
- B
- C
- D
- E
- F
- I
- K
- L
- M
- N
- P
- R
- S
- T
- U
- W
5-16
PDT 6800 Series Product Reference Guide
Running Communications
Communicating With a Host
To communicate with a host:
1. Set up the CCM 38/6860, CRD 38/6865 cradle, CRD 38/6866 cradle, or the PC
adapter as described in Chapter 2, Accessories Setup.
2. If using a cradle, place the terminal in the CCM or cradle.
3. Start the communications program on the host and terminal.
Communicating With a Printer
To communicate with a printer, attach the terminal to the Printer Interface Module (PIM):
1. Attach the PIM’s optical connector to the terminal’s optical port by inserting the clips
on the connector in the slots on either side of the port.
2. Plug the PIM’s DB-9 connector in the printer’s port.
3. Power the printer and terminal on.
Figure 5-7. Connecting the PIM to the PDT 6800 Series
Radio Communications
The PDT 6810 operates in a Symbol Spectrum One
®
RF network; the PDT 6840 Series
operates in a Symbol Spectrum24
®
RF network.
PIM
Optical Connector
Clips
Slots
Optical Port