Reference Guide
Table Of Contents
- About This Guide
- Chapter 1 Getting Started
- Chapter 2 Accessories Setup
- Chapter 3 Batch and Spectrum One Terminal Setup
- Chapter 4 Spectrum24 RF Terminal Setup
- Chapter 5 Operating the PDT 6800 Series
- Chapter 6 Maintaining the Terminal
- Chapter 7 Error Recovery and Troubleshooting
- Appendix A Null Modem Pin-outs
- Appendix B Keyboard Layouts
- Appendix C Communications Status Codes
- Appendix D Specifications
- Appendix E Boot-Up Quick Reference
- Appendix F 2D Scanner Drivers and Applications
- Numerics
- A
- B
- C
- D
- E
- F
- I
- K
- L
- M
- N
- P
- R
- S
- T
- U
- W
5-1
Chapter 5
Operating the PDT 6800 Series
Introduction
This chapter describes how to operate a PDT 6800 Series terminal, including:
!
Powering the terminal on and off
!
Booting the terminal
!
PDT 6842 - Switching 802.11 to Spring RF protocol
!
Adjusting the display contrast
!
Entering data using the keyboard
!
Entering data using the scanner
!
Communicating with a PC or printer
!
Communicating on an RF network.