Reference Guide
Table Of Contents
- About This Guide
- Chapter 1 Getting Started
- Chapter 2 Accessories Setup
- Chapter 3 Batch and Spectrum One Terminal Setup
- Chapter 4 Spectrum24 RF Terminal Setup
- Chapter 5 Operating the PDT 6800 Series
- Chapter 6 Maintaining the Terminal
- Chapter 7 Error Recovery and Troubleshooting
- Appendix A Null Modem Pin-outs
- Appendix B Keyboard Layouts
- Appendix C Communications Status Codes
- Appendix D Specifications
- Appendix E Boot-Up Quick Reference
- Appendix F 2D Scanner Drivers and Applications
- Numerics
- A
- B
- C
- D
- E
- F
- I
- K
- L
- M
- N
- P
- R
- S
- T
- U
- W
3-4
PDT 6800 Series Product Reference Guide
Initiate Terminal Communications
1. Boot the terminal to command mode.
For the 35-Key terminal:
" Press and hold <BKSP> and <SHIFT>.
" Press and release PWR.
" Release <BKSP> and <SHIFT>.
For the 46-Key terminal:
" Press and hold <F> and <I>.
" Press and release <PWR>.
" Release <F> and <I>.
The terminal displays:
COMMAND MODE
Select function
Self test
2. Scroll through Command Mode options using UpArrow or DownArrow until
"Program loader" is displayed. Press <ENTER>.
3. The terminal displays:
Program loader
WARNING: EEPROM
WILL BE ERASED
CONTINUE? <ENT>
Before loading the new application, erase the NVM’s original contents.
Note:
To cancel this operation, press CLEAR.
4. Press <ENTER> to erase the EEPROM.
Wait while the EEPROM is erased. When complete, the program prompts for the
communications parameters.