Reference Guide
Table Of Contents
- About This Guide
- Chapter 1 Getting Started
- Chapter 2 Accessories Setup
- Chapter 3 Batch and Spectrum One Terminal Setup
- Chapter 4 Spectrum24 RF Terminal Setup
- Chapter 5 Operating the PDT 6800 Series
- Chapter 6 Maintaining the Terminal
- Chapter 7 Error Recovery and Troubleshooting
- Appendix A Null Modem Pin-outs
- Appendix B Keyboard Layouts
- Appendix C Communications Status Codes
- Appendix D Specifications
- Appendix E Boot-Up Quick Reference
- Appendix F 2D Scanner Drivers and Applications
- Numerics
- A
- B
- C
- D
- E
- F
- I
- K
- L
- M
- N
- P
- R
- S
- T
- U
- W
3-1
Chapter 3
Batch and Spectrum One Terminal Setup
Introduction
Before using the PDT 6800 Series terminal, perform the following:
!
Install the battery (refer to Chapter 6, Maintaining the Terminal)
!
Charge the battery (refer to Chapter 6, Maintaining the Terminal)
!
Load the system files and application(s) (refer to Series 3000 Application
Programmer’s Guide p/n 70-16308-XX).
Hardware Requirements
Following is the equipment required to initialize a batch or Spectrum One radio terminal:
!
PDT 6800 (batch) or PDT 6810 (Spectrum One) terminal
!
One or more CCM 38/6860 or CRD 38/6866, or a CRD 38/6865
!
OR
!
PC adapter with Printer Interface Module (PIM)
!
RS-232 null modem cable
!
Power Supply
!
Host Computer.
Refer to Chapter 2, Accessories Setup for setting up the cradles or PC Adapter for
communications.