Reference Guide
Table Of Contents
- About This Guide
- Chapter 1 Getting Started
- Chapter 2 Accessories Setup
- Chapter 3 Batch and Spectrum One Terminal Setup
- Chapter 4 Spectrum24 RF Terminal Setup
- Chapter 5 Operating the PDT 6800 Series
- Chapter 6 Maintaining the Terminal
- Chapter 7 Error Recovery and Troubleshooting
- Appendix A Null Modem Pin-outs
- Appendix B Keyboard Layouts
- Appendix C Communications Status Codes
- Appendix D Specifications
- Appendix E Boot-Up Quick Reference
- Appendix F 2D Scanner Drivers and Applications
- Numerics
- A
- B
- C
- D
- E
- F
- I
- K
- L
- M
- N
- P
- R
- S
- T
- U
- W
2-6
PDT 6800 Series Product Reference Guide
2. Wet the base of each suction cup and secure the cradle to a smooth tabletop by
pushing firmly down on the cradle (Figure 2-6).
Figure 2-6. Installing Suction Cups on the CRD 38/6866
Connecting Power
Note: Connecting power to both CRD 38/6865 and CRD 38/6866 is the
same.
1. Connect the power supply cord’s round plug to the power port on the left side of the
cradle.
2. Connect the power supply’s AC plug to a standard electrical outlet.