Reference Guide
Table Of Contents
- About This Guide
- Chapter 1 Getting Started
- Chapter 2 Accessories Setup
- Chapter 3 Batch and Spectrum One Terminal Setup
- Chapter 4 Spectrum24 RF Terminal Setup
- Chapter 5 Operating the PDT 6800 Series
- Chapter 6 Maintaining the Terminal
- Chapter 7 Error Recovery and Troubleshooting
- Appendix A Null Modem Pin-outs
- Appendix B Keyboard Layouts
- Appendix C Communications Status Codes
- Appendix D Specifications
- Appendix E Boot-Up Quick Reference
- Appendix F 2D Scanner Drivers and Applications
- Numerics
- A
- B
- C
- D
- E
- F
- I
- K
- L
- M
- N
- P
- R
- S
- T
- U
- W
2-5
Accessories Setup
5. Position the cradle on the bracket.
Figure 2-5. Secure Cradle to Bracket
6. Secure the cradle to the bracket using two #10 metal screws (Figure 2-5).
Wall Mounting the CRD 38/6866
The CRD 38/6866 can be wall-mounted on two mounting brackets. Follow the directions for
Wall Mounting the CRD 38/6865 on page 2-4, using two brackets.
Table Mounting the CRD 38/6866
Note: Installing the suction cup feet is not mandatory but helps keep the
cradle in place.
1. On the bottom of the cradle, thread each of the four suction cup feet into the screw
holes.