Reference Guide
Table Of Contents
- About This Guide
- Chapter 1 Getting Started
- Chapter 2 Accessories Setup
- Chapter 3 Batch and Spectrum One Terminal Setup
- Chapter 4 Spectrum24 RF Terminal Setup
- Chapter 5 Operating the PDT 6800 Series
- Chapter 6 Maintaining the Terminal
- Chapter 7 Error Recovery and Troubleshooting
- Appendix A Null Modem Pin-outs
- Appendix B Keyboard Layouts
- Appendix C Communications Status Codes
- Appendix D Specifications
- Appendix E Boot-Up Quick Reference
- Appendix F 2D Scanner Drivers and Applications
- Numerics
- A
- B
- C
- D
- E
- F
- I
- K
- L
- M
- N
- P
- R
- S
- T
- U
- W
2-1
Chapter 2
Accessories Setup
Introduction
This chapter provides instructions for setting up the cradle, module, and PC adapter for
charging the NiCd battery and communicating with a host, printer, or modem.
Note: The Lithium Ion battery is charged in the UBC 2000 battery adapter
p/n 21-32665-24. Refer to Chapter 6, Maintaining the Terminal for
more information.
The CRD 38/6865 cradle, CRD 38/6866 cradle, and CCM 38/6860 Charging and
Communications Module provide RS-232 communication, charging, and storage for the
PDT 6800 Series terminal.
The PC adapter provides charging for the NiCd battery and communications for the terminal.
Save the shipping container for storing or shipping the cradle, module, or PC adapter. Inspect
all equipment for damage. If anything is damaged or missing, call your authorized customer
support representative immediately.