Reference Guide

1-4
PDT 6800 Series Product Reference Guide
Unpacking
Remove the clear protective tape from the display and the optical connector.
Save the shipping container for later storage or shipping. Inspect all equipment for damage
and make sure you have received everything listed on the packing slip.
If you find anything unsatisfactory or missing, contact your authorized customer support
representative immediately.
Before You Use the Terminal
Install and Charge Battery
Prior to using the PDT 6800 Series terminal for the first time, install the battery pack. Be sure
to charge the battery pack before use. Refer to Chapter 6, Maintaining the Terminal.
If you hear a repeated tone or see a message on the display, recharge or replace the battery
pack. Refer to Chapter 6, Maintaining the Terminal.
Load the Appropriate Software
What software you load and how you load it depends on the environment in which you use it:
!
If the terminal is intended for use in batch applications (PDT 6800) or in a Spectrum
One network environment (PDT 6810), refer to Chapter 3, Batch and Spectrum One
Terminal Setup for information on loading the software.
!
If the terminal is intended for use in a Spectrum24 network environment (PDT 6842,
PDT 6845, or PDT 6846), refer to Chapter 4, Spectrum24 RF Terminal Setup for
information on loading the software.
!
If you are using the 2D scan engine, install the appropriate drivers and applications.
Refer to Appendix F, 2D Scanner Drivers and Applications .