Reference Guide
Table Of Contents
- About This Guide
- Chapter 1 Getting Started
- Chapter 2 Accessories Setup
- Chapter 3 Batch and Spectrum One Terminal Setup
- Chapter 4 Spectrum24 RF Terminal Setup
- Chapter 5 Operating the PDT 6800 Series
- Chapter 6 Maintaining the Terminal
- Chapter 7 Error Recovery and Troubleshooting
- Appendix A Null Modem Pin-outs
- Appendix B Keyboard Layouts
- Appendix C Communications Status Codes
- Appendix D Specifications
- Appendix E Boot-Up Quick Reference
- Appendix F 2D Scanner Drivers and Applications
- Numerics
- A
- B
- C
- D
- E
- F
- I
- K
- L
- M
- N
- P
- R
- S
- T
- U
- W
F-23
2D Scanner Drivers and Applications
Table F-10. Decode Options Default Table
Parameter Default Value
Check Digits Parameters
Code 39 Check Digit
Disable
Transmit Code 39 Check Digit
Disable
I 2 of 5 Check Digit
Disable
Transmit I 2 of 5 Check Digit
Disable
Transmit UPC-A Check Digit
Enable
Transmit UPC-E Check Digit
Enable
Transmit UPC-E1 Check Digit
Enable
Code 11 Check Digit
One
Transmit Code11 Check Digit
Disable
MSI Check Digits
Two check digits
Transmit MSI Check Digit
Disable
MSI Check Digit Algorithm
Mod 10/Mod 10
Random Weight Check Digit
Disable
Conversion Parameters
EAN-8 Zero Extend
Disable
Convert UPC E0 to UPCA
Disable
Convert UPC E1 to UPCA
Disable
Convert EAN-8 to EAN-13 Type
Disable
Convert Code 39 to Code 32
Disable
Code 39 Full ASCII Conversion
Disable
Convert I 2 of 5 to EAN 13
Disable
UPC-A Preamble
System
UPC-E Preamble
System
UPC-E1 Preamble
System
Code 32 Prefix
Disable
Security Parameters
Linear UPC/EAN Decode
Enable
Linear Code Type Security Levels
2
UPC/EAN Security Level
0
Bi-directional Redundancy
Disable
Code 11 Redundancy
Enable
Code 39 Redundancy
Disable
Code 128 Redundancy Disable
MSI Redundancy
Enable
Codabar Redundancy
Enable
I 2 of 5 Redundancy
Enable
D 2 of 5 Redundancy
Enable
Code 93 Redundancy Disable