Reference Guide
Table Of Contents
- About This Guide
- Chapter 1 Getting Started
- Chapter 2 Accessories Setup
- Chapter 3 Batch and Spectrum One Terminal Setup
- Chapter 4 Spectrum24 RF Terminal Setup
- Chapter 5 Operating the PDT 6800 Series
- Chapter 6 Maintaining the Terminal
- Chapter 7 Error Recovery and Troubleshooting
- Appendix A Null Modem Pin-outs
- Appendix B Keyboard Layouts
- Appendix C Communications Status Codes
- Appendix D Specifications
- Appendix E Boot-Up Quick Reference
- Appendix F 2D Scanner Drivers and Applications
- Numerics
- A
- B
- C
- D
- E
- F
- I
- K
- L
- M
- N
- P
- R
- S
- T
- U
- W
F-12
PDT 6800 Series Product Reference Guide
MicroPDF decoding. Set the level to Level 3 or above to
improve MicroPDF decode performance.
UPC_CompositeUPC
Composite Linking Specifics how UPC Composite Linking is handled.
Get/Set Scan options
Uses ConsIoctlGetScanOptions or ConsIoctlSetScanOptions to get/set scan option.
laser_on_time Scanner laser on time. This parameter sets the maximum time
decode processing continues during a scan attempt. It is pro-
grammable in 0.1 second increments from 0.5 to 9.9 seconds.
aim_time Aim time. When a scanner with an aim mode is triggered, this
parameter sets the duration the aiming pattern is seen before a
scan attempt begins.
1 = 200 ms.
2 = 400 ms.
scan_mode Scan mode. Set the rastering mode of the scan engine. The fol-
lowing are the valid raster mode values: Smart Raster (0x01),
Always Raster (0x02), Slab Only Raster (0x04). Programmable
raster is not supported.
aim_modeAim mode Enable/Disable aiming.
Field Size Value/Description
Subcommand Number
BYTE 29 = Get, 27 = Set
Error Code
BYTE Not Used
laser_on_time
BYTE 5 –99
aim_time
BYTE 0 - 2
scan_mode
BYTE 1 = Smart Raster, 2 = Always
Raster, 4 = Slab Raster
aim_mode
BYTE 0 = Disable, 1 = Enable