User manual
Table Of Contents
- Introduction
- Getting Started with the SPT 1500
- Starting the SPT 1500
- Using the SPT 1500
- Maintaining the SPT 1500
- Troubleshooting
- SPT 1500 terminal does not turn on:
- Low battery warning after replacing the batteries:
- No sound:
- SPT 1500 terminal turns itself off:
- SPT 1500 terminal doesn’t recognize my handwriting:
- Tapping the screen buttons or icons does not activate the corresponding feature:
- When I tap the icon, nothing happens:
- A message appears stating that your SPT 1500 terminal memory is full:
- Beamed data does not transmit:
- When receiving beamed data an out of memory message appears:
- Your SPT 1500 unit does not accept scan input:
- Resetting Your SPT 1500 Terminal
- Regulatory Information
5
Quick Reference
To calibrate your SPT 1500:
1. Press the green power button on the front panel of your SPT
1500 to display the calibration screen.
Note: If necessary, adjust the contrast control located on the
side of the SPT 1500 so the screen is clear and readable.
2. Remove the stylus from its storage slot on the back of the SPT
1500.
3. Tap the exact center of each target that appears on the screen
with the tip of the stylus.