User manual
Table Of Contents
- Introduction
- Getting Started with the SPT 1500
- Starting the SPT 1500
- Using the SPT 1500
- Maintaining the SPT 1500
- Troubleshooting
- SPT 1500 terminal does not turn on:
- Low battery warning after replacing the batteries:
- No sound:
- SPT 1500 terminal turns itself off:
- SPT 1500 terminal doesn’t recognize my handwriting:
- Tapping the screen buttons or icons does not activate the corresponding feature:
- When I tap the icon, nothing happens:
- A message appears stating that your SPT 1500 terminal memory is full:
- Beamed data does not transmit:
- When receiving beamed data an out of memory message appears:
- Your SPT 1500 unit does not accept scan input:
- Resetting Your SPT 1500 Terminal
- Regulatory Information
3
Quick Reference
Installing Batteries
Before using your SPT 1500, you must install two AAA alkaline
batteries. The batteries fit behind the battery door on the back of the
SPT 1500.
Note: Battery life may change with different manufacturers.
Symbol Technologies recommends the use of Duracell
“Ultra” brand batteries for best battery life perfor-
mance.
To install the batteries in your SPT 1500:
1. Press the latch on the battery door and lift the battery door
away from the SPT 1500 .
2. Install the two AAA alkaline batteries into the battery com-
partment.
Note: A diagram in the interior of the battery compartment
shows the orientation of the + and - ends of the
batteries. When correctly installed, the clips in the
battery compartment secure the batteries in place.
Battery Door
Press here to
open