User manual
Table Of Contents
- Introduction
- Getting Started with the SPT 1500
- Starting the SPT 1500
- Using the SPT 1500
- Maintaining the SPT 1500
- Troubleshooting
- SPT 1500 terminal does not turn on:
- Low battery warning after replacing the batteries:
- No sound:
- SPT 1500 terminal turns itself off:
- SPT 1500 terminal doesn’t recognize my handwriting:
- Tapping the screen buttons or icons does not activate the corresponding feature:
- When I tap the icon, nothing happens:
- A message appears stating that your SPT 1500 terminal memory is full:
- Beamed data does not transmit:
- When receiving beamed data an out of memory message appears:
- Your SPT 1500 unit does not accept scan input:
- Resetting Your SPT 1500 Terminal
- Regulatory Information
15
Quick Reference
Note: You can restore any data previously synchronized with
your computer during the next HotSync operation.
To perform a hard reset:
1. Hold down the green power button on the front panel of the
SPT 1500 terminal.
2. While holding down the power button, use the tip of an un-
folded paper clip (or similar object
without
a sharp tip) to gen-
tly press the reset button.
3. When a message appears on the SPT 1500 terminal screen
warning that you are about to erase all the data stored on your
SPT 1500 terminal, do one of the following:
a. Press the upper half of the scroll button on the front panel
of the SPT 1500 terminal to complete the hard reset and
display the Digitizer screen.
b. Press any other button to perform a soft reset.
Note: With a hard reset, the current date and time are re-
tained. Formats Preferences and other settings are re-
stored to their factory default settings.