User manual
Table Of Contents
- Introduction
- Getting Started with the SPT 1500
- Starting the SPT 1500
- Using the SPT 1500
- Maintaining the SPT 1500
- Troubleshooting
- SPT 1500 terminal does not turn on:
- Low battery warning after replacing the batteries:
- No sound:
- SPT 1500 terminal turns itself off:
- SPT 1500 terminal doesn’t recognize my handwriting:
- Tapping the screen buttons or icons does not activate the corresponding feature:
- When I tap the icon, nothing happens:
- A message appears stating that your SPT 1500 terminal memory is full:
- Beamed data does not transmit:
- When receiving beamed data an out of memory message appears:
- Your SPT 1500 unit does not accept scan input:
- Resetting Your SPT 1500 Terminal
- Regulatory Information
9
Quick Reference
Using the Laser Pointer
The SPT 1500 has a Laser Pointer application installed which
allows you to use the unit as a laser pointer. The laser is emitted
from the top of the unit. To use the laser pointer:
1. Select the Laser Pointer Application Icon from the ap-
plication screen.
The Laser Pointer application screen appears.
2. Use the scanner triggers to activate the laser pointer.
Caution: No not look directly into the laser, and do not point the
laser into anyone’s eyes.
3. Sound effects can be changed by selecting “Choose Sound Ef-
fect” and then tapping on the desired sound. Then check the
Enable Sound Effects box to make effective your selected
sound effect.