User manual
Table Of Contents
- Introduction
- Getting Started with the SPT 1500
- Starting the SPT 1500
- Using the SPT 1500
- Maintaining the SPT 1500
- Troubleshooting
- SPT 1500 terminal does not turn on:
- Low battery warning after replacing the batteries:
- No sound:
- SPT 1500 terminal turns itself off:
- SPT 1500 terminal doesn’t recognize my handwriting:
- Tapping the screen buttons or icons does not activate the corresponding feature:
- When I tap the icon, nothing happens:
- A message appears stating that your SPT 1500 terminal memory is full:
- Beamed data does not transmit:
- When receiving beamed data an out of memory message appears:
- Your SPT 1500 unit does not accept scan input:
- Resetting Your SPT 1500 Terminal
- Regulatory Information
8
SPT 1500
Scanning with the SPT 1500
The SPT 1500 has an integrated scanner which, if your unit has
been configured to use scanning input, allows you to collect data by
scanning bar codes.
To scan bar codes with the SPT 1500:
1. Aim the scanner at the bar code.
2. Press either the right or left scan trigger. Make sure the red
scan beam covers the entire bar code. The green scan LED
lights and a beep sounds to indicate a successful decode.
Caution: Do not look directly into the laser.