User Manual

Preliminary
21
Quick Reference
Recharging the Battery
When necessary, recharge the batteries. To do so with the base/
charger:
• Connect the power supply to the power input port on the
front panel of the base/charger, as illustrated below.
• Connect the power supply to a receptacle supplying AC power
of the proper voltage level.
• Then place the scanner into the base/charger cradle, so that
the nose of the scanner and tip of the handle fit snugly into the
receptacles. Check the charge status indicator (blinking rapid-
ly = fully charged) for full charge, which occurs in less than
two hours. However, the scanner can be used on less than full
charge.
Charge Status LED Indications
On the base/charger, there is a red LED indicator which uses
flashing patterns to indicate the current charger status. The red
Charge Status LED indicates the following conditions:
•
RED LED OFF
— The scanner is not properly inserted or the
battery is not functioning properly.
•
RED LED blinking slowly
(1/8 sec. ON, 3/8 sec. OFF) — Bat-
tery charge is pending. This can occur if the batttery tempera-
ture is too high or low or if the battery is deeply discharged.
After several minutes, normal charging should begin.
•
RED LED ON
— The battery is actively charging. Charging
will complete in less than 2 hours.
•
RED LED blinking rapidly
(1/8 sec. ON, 1/8 sec. OFF) —
Battery charging is complete.