User's Manual

4
Battery charging
Place the battery into rear charger slot or battery and phone combination
into front charger slot. The LED indicators for each slot on the charger
indicate the following status:
– GREEN – battery is fully charged and ready for use.
– RED – battery is charging; wait until LED changes to GREEN before
using battery.
– AMBER – charger is charging the other battery. The charger starts the
first device inserted; the charging cycle for the other device starts
when the first cycle finishes.
Warnings:
To prevent injury or burns do not short-circuit the battery terminals with metal
objects.
Do not charge the battery in a charger other than a Symbol NetVision
Telephone charger
Note: Dispose of the battery properly. ((instrux TBD))
Powering on the Phone
Press SND. The phone displays the status in the LCD.
– NOTE: The Data Phone lights up the keyboard momentarily with
each button or key action. ((There is no backlight for the LCD.))
– Verify an association between the Spectrum24 network and the
phone.
After displayinging initial messages, the phone displays the message Idle
in the status display when the phone associates with a Spectrum24 AP. If the
phone cannot associate with an AP, the phone displays the message: No
Network. The phone cannot make or receive calls or communicate with
a server when it cannot establish an association with a Spectrum 24 network.
Warning: do not stare into laser beam.