User's Manual

9
Receiving Calls on a NetVision Data Phone
Answering a Call
User action to receive calls varies from no action (auto-answer mode) to
pressing any key or button. This is a user-selectable option.
The NetVision Data Phone caller ID function works only on peer-to-peer
calls.
Refusing a Call
To refuse an incoming call, press the END key.
The called phone displays:
Call Finished
The calling phone displays:
Call Declined
Note: This feature is disabled in auto answer mode.
Ignoring a Call
The NetVision Data Phone rings until the caller ends the call, the call is
refused or the PBX passes the call to voice mail, when available.
Terminating Calls on a NetVision Data Phone
End calls on the NetVision Data Phone by pressing the END key. Any user can
quit participating in an intercom call, by pressing END.
Intercom Calling
NetVision Data Phones can belong to up to 10 intercom groups. User
profiles set up by the system administrator govern access to intercom groups.
A group handles only one intercom call at a time.
Phones in the same group receive intercom calls together. Phones make calls
only to phones on the same network.
The NetVision Data Phone makes an intercom call in IP multi-cast mode. In
this mode, only one phone user talks and the rest listen. When the phone
receives an intercom call, the user presses any key or button to talk. The keys
do not activate the talk function: FCT, END, HOLD and the side-mounted
volume buttons.
Making Intercom calls
To make an intercom call:
1. Press the # key, followed by the intercom group number. Single-digits
between 0 – 9 represent the group number.
2. Press SND. The NetVision Data Phone dials the intercom group,
occupying the channel.