User Manual
Table Of Contents
- MR400 RFID Reader Module
- Table of Contents
- About
- MR400 Integration GuideIntroduction
- InstallationMR400 RFID Reader Module, Integration GuideInstallation
- MR400 RFID Reader Module, Integration Guide
- MR400 RFID Reader Module, Integration GuideMR400 SpecificationsMR400 Specifications
- Regulatory InformationRegulatory InformationMR400 RFID Reader Module, Integration Guide
- Index
Appendix B: Regulatory Information B - 7
•
Reorient or relocate the receiving antenna
•
Increase the separation between the equipment and receiver
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected
•
Consult the dealer or an experienced radio/TV technician for help.
Radio Transmitters (Part 15)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Industry Canada Statements
Radio Frequency Interference Requirements
This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est
conforme à la norme NMB-003 du Canada.
Radio Transmitters
This device complies with RSS 210 of Industry & Science Canada. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Label Marking: The Term "IC:" before the radio certification only signifies that Industry Canada technical
specifications were met.
Recycling
The Customer is responsible for complying with all recycling laws and regulations, including European
Directive: Waste Electrical and Electronic Equipment (WEEE). Symbol has no responsibility for collecting the
products sold to Customer.
RoHS Compliance
This product is RoHS compliant.
NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:.